This type of adze was used to flatten timbers, often called a foot adze because you swing it towards your foot. It will be long and curved and how you adjust the end to hang the head will affect how it cuts. You can get a handle for the square eye at House Handles. It's worth that much if you use it as an interesting paperweight. Or just go ahead and look for a Sculptor's size,one-handed adze,it'd probably be best as far as universal tool goes,and easiest to get a hang of. (a shipwright's lipped adze is particularly useful for much of cross-grain work,that is what timbers were finished with long ago). Personally,i'd hold out for an easier to manage adze.A carpenter's,or a shipwright's are the next grade up in finesse,a finer-bladed,more precision adzes though still two-handed. It's a long-handled,two-handed tool,and though there is certainly a finesse in using it,it's not exactly transferrable to the finer,more delicate/smaller finishing tasks. I would say that this particular tool,the railroad adze,is more along the lines of quick&dirty. Well.It sounds like what you have in mind is more along the lines of finer,more controlled work. I figure this would be a cheap way to get an adze to practice with. "Honestly, I've just always wanted to try an adze, and maybe do some rustic furniture building in the (far) future. The handles for these are still available.It's a compression fit,the handle goes in from the top and wedges itself,But,it takes a wedge against either the front or the back of eye to adjust the attitude/angle of attack of the tool relative your height and swing. Much depends on what in particular you'd want to accomplish with it.Īlso,it's not a particularly easy tool to get competent with may take a number of hours to get there,and it's an exhausting,hard work. That type of adze has a bevel on the inside(the handle side) Only,one problem with these is that someone always would knock back the straight,the un-bevelled side,and it takes a Lot of work to restore the strict,single-bevel configuration. It'll take some hours with a file to restore the bevel alone,but of course like anything-totally doable. That particular one you're looking at is in a pretty rough shape it'll need extensive work done on it's bevel,then the edge. Railroad adze was meant to rough-surface railroad ties,a pretty crude kind of work. There're many different types of adzes,each for their own set of purposes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |